Help Articles Device Help Setting up Manual Watering with the RC2 in the Rain Bird 2.0 App

Topic(s): Device HelpRC2 – ARC – ST8

Setting up Manual Watering with the RC2 in the Rain Bird 2.0 App

On the Controller
• To start manual watering, press the MANUAL button.
• To advance to the next zone, press the NEXT button.
• To stop manual watering on the controller, press the button.

In the Rain Bird App

  • In the controller card, Press the Button located in the bottom center of the screen to select Manual Run and then select Quick Run, Program Run, or Custom Run.
  • Notice:
  • When irrigation is active in either automatic or manual mode, the number of counts blinking in the LED will indicate which zone is active.
  • By default, each zone runs for 10 minutes; you can choose to retain or change the duration in the Mobile App.
  • In the controller, the blinking Led indicates which zone is active.
  • Access Manual Watering by pressing this icon:
  • 3 Flexible ways to irrigate manually:

Was this helpful?

-2

Do you have suggestions to make this article more helpful?

Your feedback will be used to improve this and other articles. If you would like to receive direct help please contact our Live Support at the number below. If you would like to receive a notification of article updates based on your feedback please provide your email address in the comments. Your email address will not be published.


Thank you for your feedback. We regret we are not able to provide direct responses.